Citrix Implementing Citrix NetScaler 10 for App and Desktop Solutions Sample Questions:

1. Scenario: An administrator notices that each time the secondary node of a high availability (HA) pair is restarted, the primary node shifts to a non-working state.
The administrator runs a command and collects the information displayed below:
1) Node ID. 0
IP: 172.31.250.10
Node StatE. NOT UP
Master StatE. Secondary
INC StatE. DISABLED
Sync StatE. DISABLED
Propagation: ENABLED Enabled Interfaces : 1/5 1/1 1/2 1/4 0/1 Disabled Interfaces : 1/3 HA MON ON Interfaces : 1/4 1/1 0/1 Interfaces on which heartbeats are not seen : 1/4 1/1 1/2 1/5 0/1 Interfaces causing Partial FailurE. 1/4 SSL Card Status: UP Hello Interval: 200 msecs Dead Interval: 3 secs Node in this Master State for: 0:0:0:35 (days:hrs:min:sec)
2) Node ID. 1 IP: 172.31.250.20 Node StatE. UNKNOWN/DOWN Master StatE. UNKNOWN INC StatE. UNKNOWN Sync StatE. UNKNOWN Propagation: UNKNOWN Enabled Interfaces : UNKNOWN Disabled Interfaces : UNKNOWN HA MON ON Interfaces : UNKNOWN SSL Card Status: UNKNOWN
What could be the cause of this issue?

A) Synchronization is disabled.
B) The Hello Interval is set too high.
C) One of the interfaces is disabled.
D) One of the HA Monitoring interfaces is failing.

2. Scenario: An administrator plans to publish 2010 Outlook Web Access through Citrix NetScaler AAA and allow users to authenticate using domain credentials and their RSA tokens. Users must also have the ability to change the password when it has expired.
The administrator should configure ________ for user authentication and ________ for RSA token authentication. (Choose the correct set of options to complete the sentence.)

A) SAML; RADIUS
B) LDAPS; RADIUS
C) LDAP; LDAPS
D) RADIUS; RADIUS

3. Scenario: A number of administrators received the following error when they attempted to connect to the Configuration Utility using a secured HTTPS connection:
The site's security certificate is not trusted!
One of the administrators installed a certificate from a trusted Certificate Authority on the NetScaler and is planning to configure the Configuration Utility to use this certificate.
Which NetScaler command must the administrator run at the command-line interface to configure the Configuration Utility with the new certificate?

A) set ssl service
B) bind ssl vserver
C) set ssl vserver
D) bind ssl service

4. Scenario: Two NetScaler Gateway virtual servers are configured on a NetScaler appliance. Each NetScaler Gateway virtual server is used to enable secure remote access to dedicated XenDesktop sites for separate divisions:
Division A:
NetScaler Gateway: NG-A
XenDesktop Controller: DDC-A
Division B:
NetScaler Gateway: NG-B
XenDesktop Controller: DDC-B
Each XenDesktop site is placed in its own Active Directory. Firewalls prevent any communication between the divisions.
An administrator should configure the Secure Ticket Authority on the NetScaler for Division B, without causing any configuration issues for NG-A, by binding __________. (Choose the correct option to complete the sentence.)

A) DDC-B to NG-B
B) DDC-B to NG-A
C) DDC-A and DDC-B to a load-balancing virtual server
D) DDC-B to NG-A and DDC-A

5. An administrator notices that a NetScaler high availability (HA) pair has changed the primary node several times in the past few days due to intermittent issues.
What could the administrator configure to ensure that HA failures are alerted?

A) Syslog
B) Failover Interface Set
C) Route Monitors
D) SNMP

Solutions: